Metallic DTF PRESSING INSTRUCTIONS

METALLIC DTF TRANSFER FORMULA

• As a starting point set your heat press to 305°F.
• HEAVY PRESSURE 8-9 PSI. 
• optional - Pre press for 7 seconds to remove wrinkles and moisture;
• Press for 10 seconds and Once Cold, peel backing film from garment.

 

Be Careful with fine lines as they have a tendancy to stick to the film, we've found a fast, snapping motion to be most effective when working with this material.

Use a lint roller (sticky) to remove excess foil from the edges of your design and apply a second heat press with a protective sheet.

Some adjustment may be required with your setup to get this just right for your needs. Try different settings until you are getting consistant results with your equipment.

NOTE: Although this product is amazing, as a cold peel it has certain limitations. Be sure to allow your design enough thickness so you don't loose finelines and details when peeling.